Build Gallery
1990 Ford Ranger LED Pods
Built by William R.
P-2 Pivot combo pods up front on a lifted 1990 Ford Ranger.
Get this exact setup
Everything on this build. Uncheck anything you don’t need, set quantities, and add it all in one go.
Complete the install (optional)
About this build
William R.'s lifted 1990 Ford Ranger runs P-2 Pivot LED pods up front, a 3-inch cube pod built with Cree LEDs. He went with the combo pattern, which mixes spot and flood so the pods throw light down the road and across it at the same time.
Small cube pods are a natural fit on an older compact truck like a first-gen Ranger. They add serious light without crowding the front end, and they keep the classic look intact. Lifted and ready for back roads, the Ranger now has the lighting to back it up. If you want LED pods for a Ford Ranger, compact 3-inch cube pods like these are an easy, clean upgrade that works on almost any front end. Every part is in the parts list above.
Ford Ranger lighting FAQ
What LED pods are on this Ford Ranger?
This 1990 Ford Ranger runs P-2 Pivot LED pods, a 3-inch cube pod with Cree LEDs, in the combo pattern.
How do you wire a pair of LED pods?
A Dual harness gives two leads and room to add lights later. Plug Leads are 2-to-1 and 3-to-1 waterproof plug-and-play splitters.
Do FCKLightBars lights come with a warranty?
Yes. Everything FCKLightBars sells carries a lifetime warranty.
How it’s installed
- Mount the P-2 Pivot pods up front on the Ranger.
- Use a Single harness for one light on one switch, or a Dual harness if you plan to add lights later.
- A Wireless Switch Panel runs up to 6 accessories with no holes drilled in the dash.
- Plug Leads (2-to-1 or 3-to-1 waterproof splitters) let pods share a lead plug-and-play.
